Midland BTX2 PRO S Guide D'utilisation page 22

Fixing the stereo speakers
The two stereo speakers have a Velcro/adhesive strip that aids their fixing into
your helmet. Beware not to keep the volume too high, you must always be able
to listen to the traffic sound.
Fixing the microphone
Boom Microphone
Place the section with the Velcro/adhesive strip between the padding and the
rigid cover of the helmet, so that the microphone is correctly positioned in
front of your mouth and that the white symbol is facing your mouth. This type
of microphone is suited for Open Faced and Flip Front helmets. For open
helmets it is also available a specific optional microphone cod. C1253.
Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in
front of your mouth. This type of microphone is more suited for Full Faced
helmets. The mini connector on the microphone allows you choose the mi-
crophone that best suits the helmet you are using.
Boom microphone
20
Description of the
The Midland BTX2 PRO S can be fixed onto the helmet, installing the slide-in
mounting kit in two different ways: By either using the plate with bi-adhesive
strip, or the screw plate. These methods allow you to safely "fix" the BTX2
PRO S unit onto your helmet and to remove it at any time in order to recharge
or store it.
Plate with bi-adhesive strip
The Bi-adhesive plate is already assembled on the slide-in mounting kit.
Clean the application area on the helmet surface, fold the two little wings to
better stick to the curved surface of the helmet, remove the bi-adhesive film
and place the fixing plate on the left side of the helmet by keeping it contact
with the surface for a few seconds.
Screw Clamp
Step 1. remove the bi-adhesive plate from the slide mount using the allen
wrench included in the box. Remember to keep the two screws.
Step 2. Tighten the screw plate to the slide-in mounting kit with the two pro-
vided screws.
Wired microphone
Slide-in mounting kit
Bi-adhesive
www.midlandeurope.com