Talk 2 All - Universal Intercom With Different Brand Unit - Midland BTX2 PRO S Guide D'utilisation

Conference mode with one Bluetooth device on "Vol-"
When the conference mode is active the Bluetooth device connected on
"Vol-" is still available, that mean you can listen to GPS street indication or
answer your phone call without "brake" the Conference connection chain.
The audio from the "Vol-" button connection can be "Private" (not shared in
the Conference) or "Public" (the audio is shared with conference).
By default the setting of conference mode is "Private".
Either in Privat or Public mode, if you receive a phone call, you are temporary
disconnected from the Conference, but the other people can keep on talking
to each other. As soon as the Phone call is over, you are automatically back to
the Conference.
› Activate Public mode: long press the "Vol-" button , you will here the voice
"Public"
› Activate Private mode: long press again the "Vol-" button, the voice will
tell you "Private".
Attention: the incoming phone call is always "private" even if you are in "public" mode.
Conference mode up to 8 people (4 couples)
To have 8 people conference you need to pair one intercom device also to the
"Vol- " button and be sure you selected the "Public" option.
Attention: The paring of the intercom device on "Vol-" must be as "Universal
Intercom".
By default the setting of conference mode is "Private", that mean the first
time you press long the "Vol-" button, you will hear the voice "Public". In case
you heare "Private" you need to press again "Vol-" long untill you hear the
voice "Public" mode.
How to pair an Intercom device on the "Vol-" button
› On the BTX2 PRO S go in "Setup mode", press the "Vol-" button for 3 sec.
The Blue and Red Led lights will start flashing
› On the other device, follow the procedure to pair as an Universal Intercom
How to open the Conference for the "Vol-" unit
› To open the conference from the BTX2 PRO S to the unit connected to the
26
"Vol-", press in Phone Mode the "Backward" button
› To open the conference from the other unit connected to the "Vol-", just
use the command to open the Universal intercom connection.
The maximum distance of the device connected to the "Vol-" button is 10 mt,
this is why is suitable only for Passenger.

Talk 2 All - Universal Intercom with different brand unit

Thanks to the "Talk2 All - Universal Intercom" feature it is now possible to
pair your Midland BTX2 PRO S to a different brand intercom available on the
market.
You can pair a maximum of two not Midland Intercom devices, one on the
"Forward" button and the other one on the Backward button.
› On the Midland BTX2 PRO S enter the setup mode: (with the unit OFF
press and hold down the Middle button about 7 sec. until the Red light is
on permanently).
› Keep pressed the "Forward" button or "Backward" button for 7 seconds:
the Red and Blu LED lights will start flashing fast, then (while you still keep
the button pressed) the Red and Blu LED lights will change to slow flashing.
Now you can release the button.
Talk2All-Universal Intercom
Not Midland Intercom
On the other intercom (not Midland brand) follow the procedure to pair to a
phone, because the BTX2 PRO S is paired as a Phone.
If successfully paired the red/blue lights will stop flashing and the blu light will
slowly flash instead.
Attention: remember to switch OFF all the other Bluetooth devices during the
pairing procedure, only the two devices involved in the pairing must be turned on.
To open the "Universal Intercom" communication on the Midland BTX2
PRO S while you are in "Intercom Mode", press long (3 sec) the Forward
www.midlandeurope.com