Match The Collar Receiver And Remote Transmitter; Program The System For Two Or Three-Dog Operation; Accessories - Petsafe SportDog SportTrainer SD-1225E Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
STEP :: 06

MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER

To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to work with your
existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 5-6 seconds. If the On/Off
Button is released too early, the Receiver Indicator Light will begin flashing as normal. If this occurs, start over from 1.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may
need to hold both units 60 cm - 90 cm from each other before this occurs. Once the Receiver Indicator Light has flashed
5 times, the Collar Receiver has been matched and will begin flashing as normal. If the Receiver Indicator Light does not
flash 5 times, start over from 1.
STEP :: 07

PROGRAM THE SYSTEM FOR TWO OR THREE-DOG OPERATION

SportDOG® Add-A-Dog® extra Collar Receiver(s) must be purchased to train additional dogs. Please refer to the back cover
for compatible Add-A-Dog® extra Collar Receivers for this system.
1. Program the Remote Transmitter to mode 7 (see STEP 05).
2. Program the first Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5 seconds. If the
On/Off Button is released too early, the Receiver Indicator Light will begin its normal flashing. If this occurs, start
over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You
may need to hold both units 60 cm - 90 cm from each other before this occurs. If the Receiver Indicator Light does not
flash 5 times, start over from A.
3. Program the second Collar Receiver using A through D above, but using the Lower Button in place of the Upper Button.
4. Program the third Collar Receiver using A through D above, but using the Side Button in place of the Upper Button.

ACCESSORIES

To purchase additional accessories for your SportDOG® SportTrainer® SD-1225E Remote Trainer, contact the Customer Care
Centre or visit our website at www.sportdog.com to locate a retailer near you.
SPORTDOG.COM
13

Publicité

Table des Matières
loading

Table des Matières