STEP :: 05
PROGRAM THE REMOTE TRANSMITTER
The SportTrainer® SD-1225E Remote Transmitter has seven operational modes to allow you to select the best match for your
type or style of training. The Remote Transmitter is factory set to mode 1.
TO CHANGE THE MODE
1. Referring to the following table, adjust the Intensity Dial to your
desired mode.
2. Turn the Remote Transmitter over
(remove the belt clip if attached).
3. Using a pen or the tine on the buckle of your collar strap, press
and release the Mode Button. When the Mode Button is pressed,
the Transmitter Indicator Light will be solid in colour. When it is
released, it will flash the number of times for the mode selected.
For example, if mode 2 is desired, adjust the Intensity Dial to Level 2. Once the Mode Button has been depressed,
the Transmitter Indicator Light will be solid and, once the Mode Button is released, the Transmitter Indicator Light
will flash twice.
MODE
UPPER BUTTON
FUNCTION
1
Continuous static stimulation
(Level set by Intensity Dial)
2
Continuous static stimulation
(Level set by Intensity Dial)
3
Continuous static stimulation
(Level set by Intensity Dial)
4
Momentary static stimulation
(Level set by Intensity Dial)
5
Continuous static stimulation
(Level set by Intensity Dial)
6
Continuous static stimulation
(Level set by Intensity Dial)
7
DOG 1:
Continuous static stimulation
(Level set by Intensity Dial)
NOTE: Modes 1, 2, 3, 4, 5 and 7 provide 8 levels of static stimulation, which correspond to the setting of the Intensity Dial.
Mode 6 provides more "increments" to choose from – a total of 16 levels of static stimulation. For example, in mode 6 with
the Intensity Dial set at 2, the lower button provides level 3 of 16 and the upper button provides level 4 of 16.
† The +2 Boost sends a signal to the collar to issue a static stimulation that is 2 levels higher than the currently selected level.
The system will not correct higher than level 8.
* After selecting mode 6 and while the green Indicator Light is still solid in colour, turn the Intensity Dial to the desired
Continuous Stimulation level and press the Side Button to set the level. The green Indicator Light will quickly flash
acknowledging your selection. For example, if you turned the Intensity Dial to 3, the Side Button on your Remote
Transmitter will transmit Continuous Stimulation at level 3 when pressed. If no level is selected after 15 seconds, it will
default to level 8.
12
LOWER BUTTON
FUNCTION
Momentary static stimulation
(Level set by Intensity Dial)
Momentary static stimulation
(Level set by Intensity Dial)
Tone stimulation only
Tone stimulation only
Momentary static stimulation
(Level set by Intensity Dial)
Low continuous static
stimulation (Level set by
Intensity Dial)
DOG 2:
Continuous static stimulation
(Level set by Intensity Dial)
SPORTDOG.COM
SIDE BUTTON
FUNCTION
Tone stimulation only
Vibration stimulation only
Vibration stimulation only
Vibration stimulation only
+2 Boost †
Programmable continuous
static stimulation*
DOG 3:
Continuous static stimulation
(Level set by Intensity Dial)
NUMBER OF
DOGS
1
1
1
1
1
1
3