Program The Remote Transmitter - Petsafe PDT20-12471 Manuel D'utilisation

Step

Program the Remote Transmitter

5
Note: The Transmitter is factory set to Mode 1. The Mode of the Remote Transmitter can be
changed to fi t your type or style of training.
To change the Mode:
1. Referring to the table below, adjust the Intensity Dial to
the Mode you want to use.
2. Turn the Remote Transmitter over.
3. With a pen or paperclip, depress and release the
Mode button. When the Mode button is pressed, the
Transmitter Indicator Light will be solid red. When it is
released, it will fl ash the Mode selected.
For example, if Mode 2 is desired, adjust the Intensity Dial to Level 2. Once the Mode
button has been depressed, the Transmitter Indicator Light will be solid red and once the
Mode button is released, the Transmitter Indicator Light will fl ash two times.
Note: Continuous Stimulation will transmit for no more than eight continuous seconds no matter
how long the button is pressed. To reactivate, release and repress the button.
Mode UPPER BUTTON
FUNCTION
1 Tone 1 Second then
Continuous Stimulation
2 Tone 1 Second then
Continuous Stimulation
3
4
Tone 1 Second then
Continuous Stimulation
400-1158-19.indd 11 400-1158-19.indd 11
LOWER BUTTON
FUNCTION
Tone 1 Second then
Continuous Stimulation
set by Dial 2 levels higher than
Intensity Dial setting
Continuous Stimulation
set by Dial
set by Dial
DOG #1 DOG #2
Tone only Tone only
DOG #1 DOG #2
Tone 1 Second then
Continuous Stimulation
set by Dial set by Dial
www.petsafe.net
SIDE BUTTON # OF
FUNCTION DOGS
Tone only 1
Tone only 1
DOG #3 3
Tone only
DOG # 3 3
Tone 1 Second then
Continuous Stimulation
set by Dial
9/25/09 10:41:05 AM 9/25/09 10:41:05 AM
11