Belkin Bitronics AutoSwitch Guide De L'utilisateur page 13

P73121/F1U126-KIT/EU/man.qxd
Windows
Setting up the Bitronics Software for use with 1 PC to 4 Devices
Before anything else, make sure that the drivers of the four devices are
installed on the computer already, and that each device has been tested
and works on its own.
When one computer is switching between four devices, the AutoSwitch
communicates to one device at a time only, and does not know which
device to connect to unless instructed by the user. Through the use of the
Bitronics software, the AutoSwitch receives commands from the computer,
instructing it to switch to a particular port.
Double-click on the Bitronics icon in the system tray:
The Bitronics Software will pop up:
4/28/00 1:06 PM
95 / 98 and NT
®
9
Page 9
®
(continued)
Select the correct
LPT port the
Bitronics switch is
connected to. If you
only have ONE
parallel port (usually
that is the case),
leave this in LPT1.
En