Häfele dialock DTSH Instructions De Montage page 58

G. Mount external module of Dialock DTSH door terminal
Fig. 37
Fig. 38
Fig. 39
58 Dialock Door Terminals DTSH, DTSH FH - Status: 07.2008 - 732.29.134
The following prerequisites must be complied
with:
• Holes drilled as per drilling plan
•
Door lock and locking cylinder inserted
If the distance between the surface of the door
leaf (outer) and the lock case is less than 6 mm a
spacer plate must be used, otherwise the external
module will be touching the lock cover.
Always use a stainless steel spacer
plate with DTSH FH - plastic is not
allowed!
1. Before putting on the external module, check
whether the lug of the coupling part is pointing
in direction V (see fig. 36, page 57).
2. Insert inner square spindle into lever follower
(fig. 38) and lead connecting cable through top
hole (13 mm). It is imperative to pay attention
to the cable routing!
3. If a mortise lock with emergency opening log is
being used, attach connecting cable to connec-
tor in external module and roll up connecting
cable in the 32 mm recess.
Installation Instructions