Troubleshooting Guide; Disposal Information - MIRKA LEROS 950CV Instructions D'utilisation

en
Replacing the brake seal
1 Remove the backing pad as described above
2 Pull the old brake seal out of its groove
3 Insert the new brake seal in the groove
4 Refit the backing pad as described above
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and performance, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer Service or your Mirka dealer

Troubleshooting guide

Symptom
The multi-purpose LED is flashing
between red and green.
No light from multi-purpose LED when
switched on.
The multi-purpose LED is red and the
sander slows down to 4,000 rpm when
sanding.
The multi-purpose LED is red and RPM
is slightly reduced.
Brake seal does not work.
The sander has stopped and multi-
purpose LED is red.

Disposal information

DANGER
Disposal guidelines for old appliances Render redundant power tools unusable by removing the
power cord Only for EU countries: Do not dispose of electric tools along with household waste
According to European Directives 2002/95/EC, 2012/19/EU and 2003/108/EC on waste electrical and
electronic equipment and their implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility
46
Mirka® LEROS Random Orbital Sander • 225 mm (9")
Possible cause
Connected to a mains outlet with wrong
voltage
Power cord not properly attached to the
sander or to the mains socket
Temperature too high in the sander Too
heavy long-term load
Too heavy short-term load
Worn out brake seal or damaged spindle
bearing
The tool is in safety mode due to high
temperature
Solution
Connect the sander to a mains outlet that
matches the nominal voltage of the tool
Connect it properly
Reduce the load on the sander for some
time and the sander will speed up again
Use lighter load and the multi-purpose
LED will automatically change to green
Check and replace brake seal or spindle
bearing if necessary
Wait until the tool has cooled down