Charging Time - Sony Handycam NEX-VG20 Mode D'emploi

4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.

Charging time

Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack
NP-FV70 (supplied)
NP-FV100
The charging times shown in the table above are measured when charging the camcorder at a

temperature of 25 C (77 °F). It is recommended that you charge the battery in a temperature range of

10 C to 30 C (50 °F to 86 °F).
 
Tips

See page 66 on recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the

remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
Slide the POWER switch to OFF. Slide the BATT (battery) release lever () and remove the
battery pack ().
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 3: Charging the battery pack" (p. 16). Even if the battery
pack is attached, the battery pack is not discharged.
Charging time
195
390
BATT (battery) release lever
US
1