Function 2: Actuator With Code Mode; Compatibility Table - Comelit HFX-7000M Manuel Technique

4.9.2.3 FUNCTION 2: ACTUATOR WITH CODE MODE

√ NOTE: Before programming the module, see the table:
By pressing the button programmed as "coded actuator", it is possible to toggle between the different cameras.
Microswitch "S1" must be set as shown in following table:
DIP DIP DIP
1 2 3
1 0 0
1 0 1
1 0 0
1 0 1
1 0 0
1 0 1
1 0 0
1 0 1
Example of Address setting on Art.
1409 for control using actuator code
In this mode, with the video entry phone monitor switched on, by repeatedly pressing the actuator with code pushbutton, it is
possible to cycle through ONLY the cameras connected to module 1409 with the corresponding address.
In the same system, it is possible to install up to 8 1409 modules with different codes.

4.9.2.4 COMPATIBILITY TABLE

34
DIP DIP DIP
Address 1409
4 5 6
0 0 0
0 0 0
1 0 0
1 0 0
0 1 0
0 1 0
1 1 0
1 1 0
DIP 1
1
224.
Compatibility with 1256 No 1256 in "Generic actuator mode"
Compatibility with 1409 No other 1409
"4.9.2.4 Compatibility Table" on page 34.
Correspondence of 1409 address actuator with code on bracket
0
1
2
3
4
5
6
7
DIP 2 DIP 3 DIP 4
0 0 0
COMPATIBILITY OF 1409 WITH 1256 OR OTHER 1409
Generic actuator mode
Actuator on bracket code
220
221
222
223
224
225
226
227
DIP 5 DIP 6
1 0
Actuator with code mode
No 1256 in "Actuator with code mode" with
codes between 220 and 227
Only 1409 in "Actuator with code mode" with
different codes