Contents Of Cardboard Packaging; Conformity Of Use; Way Of Functioning - Roller Grill GR 40 G Notice D'installation Et D'utilisation

- Do not leave the pipe or hose (purchased separately
from a specialised shop) in the contact of hot surfaces.
- The appliance should not be used close to combustible
materials.
- During use, look after not to obstruct hearings of aera-
tion of the appliance.
- Do not bend or clip the pipe or hose.
- Entrust compensations only to a skilled person.
- Use only spare parts of origin.
- At the end of cooking, before cleaning the appliance,
do not forget to disconnect the gas inlet.

2. CONTENTS OF CARDBOARD PACKAGING

Device: a gyros grill
Accessories: - A spit
- A set of natural gas injectors
- The present note
Options: - Stainless steel protection
- Stainless steel reflectors
- Panoramic glass doors
- Electric knife holder
- Electric knife
- Set of 4 spits ref BG1
- Set of 12 barbecue skewers ref BG4
- Meat pan
See exploded views for each gyros grills at the end of the document.

3. CONFORMITY OF USE

Use the device only to cook homogeneously a piece of meat.

4. WAY OF FUNCTIONING

The gyros grills are available in 6 versions (2 energies: gas or electric and 3 heights
of spit). According to the height of the spit, you can roast 15, 25 or 40 kg of meat.
The mobile parts of these devices are put on ball bearings, so the engine is not axial
loaded.
The travel of the trolley is possible after having loosened the 2 side screws. It ena-
bles to adjust the distance between the meat and the cooking zone.
The switch (n° 1 on picture) in front side allows starting the motor.
In case of breakdown of the motor, you can remove the beta pin for a manual rota-
tion of the spit.
To turn on the gyros grill, press on the power control knob (n°3 on picture) opposite
the star position for a few seconds and approach a long matchstick or a gas lighter
near the burner (n°2 on picture). Keep the knob pressed (n°3 on picture) for 15 sec-
onds.
While cooking, the temperature can be regulated using the control knob (n°3 on pic-
ture) from high flame to low flame in order to avoid over-cooking.
A safety thermocouple cuts the gas supply if the burner is extinguished.
It is recommended to turn off the burner on the spit is empty to avoid excess heat-
ing.
The low flame of the appliance is pre-adjusted in the factory, it must not be changed.
1
1 On/off switch
3
Power control knob
14
2
3
Burner
2
15