Selecting A Dsp Program - Yamaha RX-V420RDS Mode D'emploi

PLAYING A SOURCE

Selecting a DSP Program

You can enhance your listening experience by selecting a
DSP program. Refer to "SOUND FIELD PROGRAM" for
details about each program.
y
• Make sure that the sound effect is turned on (see page 25).
D I G I T A L
STANDBY SURROUND
/ON
BASS TREBLE BALANCE SPEAKERS
A B
PROGRAM
+ +
– – L R ON OFF
PHONES
SILENT
PROGRAM
DSP
PRG+,PRG–
Press PROGRAM l or h (or DSP PRG+ or
PRG–) repeatedly to select the desired
program.
The name of the selected program appears for a
moment and the selected DSP program indicator lights
up on the display.
PROGRAM
Front panel
DIGITAL
DSP
y
• If desired, adjust the delay time and the sound output level of each
speaker. (Refer to "DELAY TIME AND SPEAKER OUTPUT
LEVELS" on page 40 for details.)
24
D I G I T A L
RDS MODE/FREQ EON
PTY SEEK
MODE START
INPUT MODE
PRESET
/TUNING FM/AM
EFFECT PRESET/TUNING A/B/C/D/E
EDIT
TUNING
MEMORY MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
VIDEO L AUDIO R
VIDEO AUX
/
or
Remote control
MOVIE THEATER 1
BASS EXT.
DSP program name
Notes
• Choose a DSP program based on your listening preference, and
not on the name of the program. The acoustics of your listening
room affect the DSP program. Minimize the sound reflections in
your room to maximize the effect created by the program.
• When you select an input source, this unit automatically selects
the last DSP program used with that source.
• When you set this unit in the standby mode, the current source
and DSP program are memorized and are automatically selected
when you turn on the power again.
VOLUME
• If a Dolby Digital or DTS signal is input when the input mode is
set to AUTO, the DSP program automatically switches to the
appropriate decoding program.
6CH INPUT
• When a monaural source is being played with PRO LOGIC/
INPUT
NORMAL or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if "CENTER SP" in the
SET MENU is set to NON, the center channel sound is output
from the main speakers.
• When a source connected to the 6CH INPUT jacks of this unit is
selected, the digital sound field processor cannot be used.