Control Elements En; Putting Out Of Operation - Abicor Binzel xFUME FLEX Mode D'emploi

8 Putting out of operation

7.1 Control elements
8
7
6
1 Extraction arm
2 Handle
Fig. 5 Control elements
1 Adjust the extraction arm (1) to accommodate the work task.
2 Adjust the extraction hood (6) to accommodate the work task. The extraction hood must be located approx. 20 cm above
the welding point during operation.
3 Establish an electrical connection.
4 Switch on the LED light (7) on the extraction hood (6).
5 Adjust air volume to the work task.
6 Use the On/Off switch (4) to switch on the device.
8 Putting out of operation
 Fig. 5 Control elements on page EN-14
1 Use the ON/OFF switch (4) to switch off the extraction system.
2 Disconnect the extraction system from the power supply.
EN - 14
1
2
3
4
5
3 Service door 5
4 On/Off switch 6
4 castors 7 LED light
Extraction hood 8 Light switch
BAL.0733.0 • 2020-07-10
xFUME FLEX