Torch Handle Control Elements; Trigger Function - Abicor Binzel ABIMIG A Série Mode D'emploi

6 Operation
1 Lay the cable assembly connected to the machine side out straight.
2 Insert the wire into the wire feeder as specified by the manufacturer.
3 Press the 'zero-current wire feed' trigger on the wire feeder until the wire comes out of the
contact tip.

5.9 Torch handle control elements

NOTICE
• The ABIMIG
see TRBS 1203).
• Please also consult the operating instructions for the welding components, welding power
source and welding torch.
The trigger's two-cycle mode can be activated when using a standard welding torch. Further
operating modes (e.g. 4-cycle) and torch handle modules depend on the welding power source
and must be ordered separately.

5.9.1 Trigger function

1 Press and hold the trigger on the handle = start welding.
2 Release the trigger = stop welding.
6 Operation
1 Open the shielding gas cylinder.
2 Switch on the power source.
3 Switch on the coolant recirculator for ABIMIG
4 Rinse the shielding gas lines.
5 Start the welding process by pressing and holding the torch trigger.
EN - 16
®
welding torch must only be operated by qualified personnel (in Germany,
® ®
W / ABIMIG W T.
BAL.0402.0 • 2018-08-24
®
ABIMIG