Elba P60 Série Mode D'emploi page 24

IMPORTANT:
Never attempt to turn the elbow
"A" without having first slackened
off the relative lock nipple.
The gaskets "D" (fig. 5.1) are the
elements that guarantees the seal
in the gas connection.
It is recommended that they be
replaced whenever they show even
the slightest
imperfection.
After connecting to the gas supply,
check that the couplings are
correctly sealed, using soapy
solution, but never a naked flame.
The connection with rigid metal
pipes should not cause stresses to
the hob manifold.
If the rubber tube is used for the
gas connection:
- Make sure the tube is snugly fit
at both ends and use a standard
tube clamp (not supplied) to
fasten it.
- The rubber tube must be as short
as possible, without contractions
or kinks.
- The rubber tube must not be, at
any point of its length, in contact
with the "hot" parts.
- From time to time check to make
sure that the rubber is in perfect
condition and substitute it at the
printed due date or if it shows
signs of wearing or damage.
24
deformation or
GAS MAINTENANCE
OPERATIONS TO BE PER-
FORMED WHEN SUBSTITUT-
ING THE INJECTORS
Remove the pan-supports, the burner
covers and the knobs;
Using a wrench substitute the injec-
tors "J" (Fig. 5.3 - 5.4) with those ones
suitable for the type of gas for which it
is to be used.
The burners are conceived in such a
way so as not to require the adjust-
ment of the primary air.
Fig. 5.3
Fig. 5.4
J
J