Elba P60 Série Mode D'emploi page 18

TECHNICAL INFORMATION FOR THE INSTALLER
In order to install the cooker top into the kitchen fixture, a hole with the dimensions
shown in fig. 4.1 (for cooker top P90) o 4.2 (for cooker top P60) has to be made, bearing
in mind the following:
within the unit, between the bottom of the cooktop and the upper surface of a shelf
there must be a clearance of at least 30 mm.
It is absolutely essential that you place a separator between the base of the cooktop
and the built-in unit or the oven;
the cooker top must be kept no less than 200 mm away from any side wall (figs. 4.1
- 4.2);
the hob must be installed at least 60 mm from the wall;
there must be a distance of at least 650 mm between the hob and any wall cupboard
or extractor hood positioned immediately above (see figs. 4.3-4.4);
if the hob is installed over a built-in oven, there must be a distance of at least 30 mm
between the two appliances. The two appliances should be connected to the gas sup-
ply with independent connections.
Fig. 4.1
Fig. 4.2
18