Télécharger Imprimer la page

Aqua Medic multi reactor S Mode D'emploi page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
The Aqua Medic multi reactors S, M and L are plug-and-play reactors for use within the aquarium or filter
sump, and can be used for fresh and saltwater aquaria for up to 350 l/92 gal, 500 l/132 gal or 800 l/211 gal
respectively.
1. Technical Information
multi reactor
Dimensions (l x w x h)
Filling quantity
Voltage
Current consumption
Pump power
For aquaria
2. Set-Up and Operation
Pict. 1: 1. Holding unit 2. Turning knob (flow regulator) 3. Sponge 4. O-rings 6. Outlets
If the sponge (3) is dirty and needs to be cleaned, shut-off the pump, open the filter body and clean the sponge
with water.
Our multi reactors S, M and L are designed to operate either directly inside the aquarium or inside the filter
sump. With the supplied holding unit, the multi reactor can be mounted horizontally on the aquarium glass. The
pump needs to be fully submerged to prevent air suction. The entire body can be submerged up to the outlets
(6) on top of the unit. The immersion depth of the unit can be adjusted by opening the clamp screw.
When filling the unit, pull on the handle, attached to the inner tube, all the way out of the outer tube.
5
Operation Manual ENG
S
app. 60 x 50 x 315 mm
app. 150 ml
220 - 240 V / 50 - 60 Hz
12 V / app. 4 watts
app. 200 l/h
up to 350 l
M
app. 80 x 60 x 380 mm
app. 350 ml
220 - 240 V / 50 - 60 Hz
12 V / app. 8 watts
app. 350 l/h
up to 500 l
L
app. 100 x 100 x 465 mm
app. 650 ml
220 - 240 V / 50 - 60 Hz
12 V / app. 14 watts
app. 450 l/h
up to 800 l

Publicité

loading

Ce manuel est également adapté pour:

Multi reactor mMulti reactor l