Getting Started; Choosing Tone Or Pulse Dialing; Setting The Dial Mode; Using Touch-Tone Services With Pulse Dialing Systems - Sony ID Telephone SPP-ID200 Mode D'emploi

Choosing tone or pulse dialing

Setting the dial mode

!
Make a trial call before catching
the AC power adaptor cord on
the hook as described on page 9.

Using touch-tone services with pulse dialing systems

!
You only need to press TONE Z
once to turn dialing to tone; this
will remain in effect until the call
is disconnected.
14

Getting started

For the telephone to work correctly, you must set it to the type of
your dialing system: tone or pulse dialing.
DIAL MODE switch
TONE Z key
Set the DIAL MODE switch to:
T (tone) if your dialing system is tone.
P (pulse) if your dialing system is pulse.
p If you are not sure
1 Make a trial call with the DIAL MODE switch set to T.
2 If the call connects, leave the switch at T.
Otherwise, set the switch to P.
Some services require you to use touch-tone. This is not a problem if
your phone already uses tone dialing. If your phone uses pulse
dialing, however, you need to follow the steps below to use these
services.
For details on making calls, see the "Making calls" section (page 17).
1
Dial the service's number.
2
When connected to the service, press TONE Z.
3
Press the dialing keys as required.
SPP-ID200(EF) 3-810-886-21(1)