Preparing The Battery Packs; Charging The Battery Packs - Sony ID Telephone SPP-ID200 Mode D'emploi

Preparing the battery packs

Charging the battery packs

!
If a battery pack is brand new or
completely discharged, it may
take 10 minutes or more before
the CHARGE lamp lights.
The two supplied battery packs must be charged before you can use
them. One should be inserted into the handset to operate it. The other
may remain in the base unit to allow for a continuous supply of fully
charged battery packs. Also, should any power interruption occur,
the battery in the base unit will provide backup power during the
interruption.
1
Insert one of the supplied battery packs
completely into the charging compartment.
The CHARGE lamp on the base unit lights.
2
Charge the battery pack for about 10 hours.
When charging is completed, the CHARGE lamp goes off.
p Note
Make sure that the base unit is connected to a continuous power
supply.
If the base unit's power supply is interrupted (for example, if
power is cut off every night), then the battery will provide backup
power, and will be discharged. Frequent charging and
discharging will shorten the battery's life.
If the base unit is not connected to a continuous power supply,
the battery charged in the base unit will be effective for a shorter
period of time than a fully charged battery pack when installed in
the handset.
Battery pack
SPP-ID200(EF) 3-810-886-21(1)
11
Setting up