Before First Use; Adding Salt - Zanussi ZDI26001XA Notice D'utilisation

DEACTIVATING THE RINSE AID EMPTY NOTIFICATION
While the appliance is in user mode:
1. Press .
• The indicators
• The indicator
• The display shows the current setting:
– = rinse aid empty notification activated.
– = rinse aid empty notification deactivated.
2. Press to change the setting.
3. Press on/off button to confirm the setting.
When rinse aid chamber is empty, the rinse aid indicator is turned on notifying to refill rinse
aid. If you are using multitabs containing rinse aid and you are satisfied with the drying result,
you can deactivate the notification for refilling rinse aid. However, we recommend that you
always use rinse aid for best drying performance.
If you use standard detergent or multitablets without rinse aid, activate the notification to keep
the rinse aid refill indicator active.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container with special salt for
dishwasher.

ADDING SALT

Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after
you fill the salt container, start a programme.
and are off.
continues to flash.
3. Fill the rinse aid dispenser with special rinse
aid for dishwasher.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
Do not use detergent and do not load the
baskets.
25