Installation - Seko WAREDOSE 35 Manuel D'installation

EN
WAREDOSE 35
2.

INSTALLATION

Mount the unit on a nearby wall (using suitable hardware) to the warewasher. Try to keep the unit within one meter
from the final rinse line to avoid long tubing runs.
Locate the WAREDOSE 35 as close to the chemical product tanks as possible in order to maximize both your
motor and tube life.
Check all applicable plumbing and electrical codes before proceeding with the installation. This will help to ensure
that the system is installed in safe and suitable manner. A wiring schematic of the warewasher should be used as
reference for making electrical connections, this is typically provided by the warewasher manufacturer if one cannot
be located on the machine itself.

CAUTION: Do not mount the unit in the direct path of steam. This can short circuit and permanently
damage the unit. Mounting the unit on the side, on the back or on the vents of the warewasher may cause
thermal overload and damage or hinder the performance of the unit.
2.1 MOUNTING THE SYSTEM
Apply the panel unit system with the brackets and screws supplied:
• Determine a suitable location for the system;
• Using the bracket as a template, mark and drill holes for bolting the system to the wall;
• Insert the anchors in the holes;
• Bolt the bracket in place (flat side against the wall with holes on bottom) with the hardware provided;
• Attach the main unit by sliding the appropriate slot on the back of the unit onto the mounted bracket;
• Open the Cabinet Front, unscrewing the upper screws by ¼ of a turn.
2.2 PLUMBING
2.2.1 Detergent Plumbing
The following installation steps apply for the detergent pump:
Suction Line:
Assemble the foot filter to insert into the detergent tank. Insert the inlet PVC tube through the flat side of the weight
and out the other side. Push the filter into the end of the tube. Lock the tube onto the filter by pushing the weight to
the filter holder and rotating it at the same time, till they are completely flush (Picture 2).
0000138112
Picture 2
rev. 1.0
weight
1/4'' OD PVC tube
Filter
4