Basic Functions And Programming - Seko WAREDOSE 35 Manuel D'installation

EN
WAREDOSE 35
5.

BASIC FUNCTIONS AND PROGRAMMING

DISPLAY READING
1 WAREDOSE 35
2 PRIMING DET 60s
3 PRIMING RIN 60s
4 <set PAUSED esc>
5 <prog data>
0000138112
DESCRIPTION
POWER ON MESSAGE:
When power is switched on, the display will briefly show the firmware
code and its revision, and go through a self-test routine.
Then it will show the DEFAULT DISPLAY, that is "WAREDOSE 35"
This message can be changed as described later.
In Probe Mode the set point and concentration screen will be
alternating with the previous message.
E.G SP:1,8mS C:1,2mS
PRIMING
On the previous screen, press the left button for about 3 seconds to
prime the detergent pump (60 second shot). This also allows you to
quantify the delivery rate of your chemical. Priming the pumps can be
done without accessing the program. The priming can be stopped by
pressing the same button again.
PRIMING
On the previous screen, press the right button for about 3 seconds to
prime the rinse aid pump (60 second shot). This also allows you to
quantify the delivery rate of your chemical. Priming the pumps can be
done without accessing the program. The priming can be stopped by
pressing the same button again.
ACCESSING THE MENUS
By pressing the central button, the display will appear as shown on the
left.
•
Press the left button, SET, to program the device or to scroll
through the statistics.
•
Press the right button, ESC, to return to the default display or
to normal running mode.
While the display remains on this menu, the system is PAUSED and
no dosing will be performed, no matter on what happens on the S1,
S2, S3 inputs.
PROGRAMMING and STATISTICS
By pressing the left button, set, in the previous condition, the message
shown on the left will appear.
In this condition:
•
Press the right button, data, if you want to see the statistics
collected by the device
•
Press the left button, prog, to access the section to program
the device.
rev. 1.0 8