Continuous Display Of Measured Result (Hold) - Seca 285 Mode D'emploi Et Garantie

Continuous display of
measured result
90 •
5. Ask the adult to step onto the scales with the child.
The child's weight is displayed.
The
messages "HOLD" and "NET" are displayed.
6. To disable the 2 in 1 function, press the 2 in 1 key
or switch off the scales.
If you activate the HOLD function, the weight value
continues to be displayed after the load has been
removed. This allows you to attend to the patient
(HOLD)
before noting down the weight.
1. Ensure that there is no load on the scales.
2. Press the Start key
display.
3. Ask the patient to step onto the scales.
4. Press the hold key.
The display flashes until a stable weight is
measured. The weight value is then displayed
continuously. The
function) and the message "HOLD" are displayed.
5. To disable the HOLD function, press the hold key.
The
longer displayed.
ATTENTION!
Incorrect measurement due to changing initial
weight
If the child is weighed with a different initial
weight, the child's weight cannot be calculated
correctly.
− Ensure that the child is always weighed with
the adult used to determine the initial weight.
− Ensure that the weight of this adult does not
change, e.g. as a result of taking off a
garment.
symbol (non-calibratable function) and the
symbol (non-calibratable
-symbol and the "HOLD" message are no
of the multifunctional