Installation - Conrad FHT 8W Notice D'emploi

c) Installation
• The device must be mounted solidly in one location, e.g. on a wall with screws.
• Screw out the four cover screws and open the housing by lifting the cover.
• Mark the holes to be drilled using the four housing holes (2 - location see figure on next page).
• Drill the holes in the wall and insert the screw anchors.
When drilling the holes, make sure not to damage any cables, power lines or pipes!
• Attach the device with screws matching the
screw anchors through the four housing holes
(2). The cable inputs (3) should be pointing
downwards.
• Unscrew the four plastic screws (1) on the
front plate and remove it.
• Then unscrew the four plastic hexagonal bolts
(4) and remove the control circuitboard from
the device.
28
1
2
2
1
4
4
1
1
3
4
4
2
2