Wilo Veroline IP-E Notice De Montage Et De Mise En Service page 45

ENGLISH
10
11
40
LC display
Enabling / disabling the external pressure set valuePossible settings:
0-10V; 2-10V; 0-20mA; 4-20mA
The signal is present at terminal IN2 in the terminal box.
CAUTION: Do not confuse with the ACTUAL value signal on terminal
IN1!
The setting involves 3 steps.
1. Enable / disable input IN2 in this menu
X
2. V / mA in menu
11
3. Select range of values in next menu
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
The display jumps to the next menu:
X
IN2 = on -> Menu
11
X
IN2 = off -> Menu
13
Note:
X
If IN2 is active, menu can no longer be selected
4
Setting the signal type for the set pressure value (step 2)
The menu comes after the above menu
Selecting the signal type: [V (Volt) / mA (Milliampere)]:
Turn tuning button to toggle between .V (Volt) and mA (milli-
ampere).
The new setting blinks.
Press button to store the new setting.
X
Menu is displayed.
12
X
If IN2 is active, menu can no longer be selected.
4
Setting
X
.
10
X
12
X
11