Truma CP Mode D'emploi Et Instructions De Montage page 32

3. ACC
1
The automatic climate control function AUTO is activated or
blocked with "ACC".
ON – The automatic climate control function AUTO is ac-
tivated. Automatic climate control function AUTO
can be selected in the Room temperature menu.
– "AC SET" appears in the Service menu.
OFF – The automatic climate control function AUTO is
blocked.
Fig. 25
Presetting: OFF
The function of the Truma automatic climate control de-
pends on proper installation. Your Truma dealer/partner
would be pleased to advise you whether your vehicle is suitable.
Requirements for the automatic climate control functioning as
expected:
1. The air conditioning system and heater cover the entire
area of the vehicle that is supposed to be automatically air
conditioned.
2. The room temperature sensor of the heater is the lead sen-
sor of the automatic climate control and must therefore be
in a suitable location, i.e.
– in the area in which the required room temperature
should be reached.
– if possible not influenced by outside temperature or
sunlight.
32
– not close to warm air ducts, cold air ducts or other sourc-
es of heat.
– warm or cold air from the air outlets must not flow
against the room temperature sensor. Particular attention
must be paid to this when adjusting the air throttles on
Aventa air conditioning systems.
– with good circulation and not on the vehicle ceiling.
Truma dealers / Truma partners are trained in the correct in-
stallation of the automatic climate control. You can find our
dealers / Truma partners at www.truma.com.
4. °C / °F temperature display
Select the temperature display °C (Celsius) or °F (Fahrenheit).
Fig. 26
Presetting: °C (Celsius).
5. Changing the background lighting
Change the background lighting of the Truma CP plus VarioHeat
control panel in 10 increments.
Fig. 27