Working; Combustion Adjustment; Combustion Head Setting - Riello GULLIVER BS1 Manuel D'entretien

4.

WORKING

4.1 COMBUSTION ADJUSTMENT

In conformity with Efficiency Directive
92/42/EEC the application of the burner on the
boiler, adjustment and testing must be carried
out observing the instruction manual of the
boiler, including verification of the CO and
CO concentration in the flue gases, their
2
temperatures and the average temperature of
the water in the boiler.
To suit the required appliance output, choose
the proper setting of the combustion head, and
the air damper opening.

COMBUSTION HEAD SETTING

It leaves the factory set for the minimum
output.
It depends on the output of the burner and is
carried out by rotating clockwise or counter-
clockwise the setting screw (6) until the set-
point marked on the regulating rod (2) is level
with the outside plane of the head assembly
(1) (see fig. 9).
NOTE
The diagram is orientative; to assure a good
working of the burner, we suggest to adjust
the combustion head according to the boiler.
HEAD ASSEMBLY REMOVING
To remove the head assembly, carry out the
following operations:
Remove the head-older assembly (1), after
taking away the screws (7), disconnect the
connections (3 and 5), extract the small tube
(4) and loose the screws (10).
Do not modify the setting position of the brack-
et-elbow during the disassembly.
REASSEMBLY OF THE HEAD SYSTEM
WARNING
During the reassembly of the system,
tighten the screws (7) completely (with-
out locking them) ; then lock them with a
torque wrench setting of 3 - 4 Nm.
Control that, during the working, there
are not gas losses coming from the
screws.
If casually the pressure test point (11)
looses, fix correctly and be sure that the
hole (F), placed in the external side of
the head-assembly (1) turns towards the
lower part.
2146
Fig. 9
kcal/h kW
250
210,000
230
210
170,000
190
170
130,000
150
130
110
90,000
90
70
50,000
50
30
10,000
10
0 2
D5210
7 GB
912T1
911T1
4 6 8
Set point
S7004
10