Hülsta SIMIA Mode D'emploi page 51

ELEMENTS SUSPENDUS D'UNE PROFONDEUR DE 45,0 CM - MONTAGE MURAL – CARACTERISTIQUES INDISPENSABLES POUR LA COMPOSITION DU MUR
MONTAGE · ASSEMBLY · MONTAGE · MONTAGE
Attention! Be sure to have the nature of the wall checked by qualified personnel before assembly. Assembly should only be carried out by qualified persons
assembly instructions must be strictly adhered to. The sets of mounting brackets are only suitable if the nature of the wall and the pressure resistance levels meet those
stated in the table below. The unit cannot be mounted on light walls. Please note that a different mounting method must be chosen by qualified personnel for other
types of wall. hülsta cannot be held responsible for the correct choice of any other type of mounting. When mounting the unit, please also make sure that there are no
electrical installations or other utility lines near the mounting area. Check this using an appropriate search device. Please note that plastic pipes will not be detected.
Mounting set 1 (Mat. no.1410886)
for 2 wall connection points
1x
TVM-STV-K 280
6x
TVM-IGA 6x93
The set is only suitable for use in connection with the types of walls stated below.
Please note that the pressure resistance levels must under no circumstances fall
below those stated.
Optional mastic gun (Mat. no.1410888 / type 38)
(Vertically) perforated bricks
Hollow light concrete
blocks
min. 5 mm
Anchoring depth
Depth of drilled hole
MONTAGEANLEITUNG
HÄNGEELEMENT 45ER TIEFE
WANDBEFESTIGUNG -NOTWENDIGE WANDBESCHAFFENHEIT
WALL UNITS 45.0 CM DEEP - WALL MOUNTING - REQUIRED STRUCTURE OF WALL
HANGELEMENTEN 45,0 CM DIEP - WANDBEVESTIGING - VEREISTE WANDSTRUCTUUR
2x
TVM-Z-SM
TVM-Z-SH 16x105
6x
DIN 125 / 6.4
DIN 933 / 6x20 8.8
1x
Pressure resistance
>/= 4 N/mm²
Pressure resistance
>/= 2 N/mm²
Mounting set 2 (Mat. no.1410887)
6x 1x
TVM-STV-K 280
6x 9x
TVM-Z-SH 16x105
9x
DIN 933 / 6x20 8.8
The set is only suitable for use in connection with the types of walls stated below.
Please note that the pressure resistance levels must under no circumstances fall
below those stated.
Recommended kind of drilling:
Rotary drilling: With a normal power drill, without percussion
in perforated bricks (so that the connecting sections do not break and
the hollow section become too large). Holes must always be thoroughly
cleared of any drilling remains afterwards.
Recommended kind of drilling:
Rotary drilling: With a normal power drill, without percussion
in perforated bricks (so that the connecting sections do not break and
the hollow section become too large). Holes must always be thoroughly
cleared of any drilling remains afterwards.
Depth of drilled hole
The hole itself must be deeper than the depth of anchoring.
Please also follow the additional enclosed information about
compound mortar from the Tox Company to ensure correct
SIMIA
qualified persons and the
for 3 wall connection points
1x
TVM-Z-SM
TVM-STV-K 150
9x
DIN 125 / 6.4
TVM-IGA 6x93
without percussion setting
without percussion setting
mounting.
4x
9x
SEITE 51