Assembly Kit; Assembly Instructions - Sportplus SP-HG-010 Mode D'emploi

No. Description
40 Ball pins
41 Weight plate pin
42 Chain
43 Weight mounting pulley (L: 2500 mm)
44 Butterfly cable (L: 3060 mm)
45 Low cable (L: 4050 mm)
46 Leg padding (L: 170 mm)
47 Hand padding
48 Round head grooved pin
49 L-shaped locking pin
50 Plastic guide
51 Plastic sleeve
52 Cable tie
53 Support plate
54 Protective cover
55 Protective sleeve

4. ASSEMBLY KIT

No. Description
1a Bolt (M8 x 65 mm)
2a Bolt (M8 x 16)
1b Bolt (M8 x 60 mm)
2b Curve Washer (Ø8)
3b Nut (M8)
1c Bolt (M6 x 15 mm)
2c Washer (Ø6)
1d Bolt (M8 x 20 mm)
2d Washer (Ø10)
3d Nut (M10)
1e Bolt (M8 x 45 mm)
1f Bolt (M12 x 125 mm)
2f Washer (Φ12)
3f Nut (M12)
1g Bolt (M12 x 85 mm)
1h Bolt (M8 x 25 mm)
1j Bolt (M8 x 60 mm)
1k Bolt (M8 x 75 mm)
1l Bolt (M8 x 50 mm)
1m Bolt (M8 x 85 mm)
1n Bolt (M12 x 75 mm)
1p Bolt (M8 x 65 mm)
SP-HG-010-IM-DE+GB+FR-02.indb 20-21
Quantity
2
1
1
1
1
1
4
8
1
1
14
14
4
2
4
2
Quantity
4
2
2
4
2
2
2
4
56
23
1
1
14
7
4
2
7
8
2
1
2
2
20

5. ASSEMBLY INSTRUCTIONS

Step 1:
55
53
54
53
2
1k
2d
11
2d
11
• Attach the rear base frame (4) to the front base frame (11). To do so, use the support
plate (17) and the bolts (1k), washers (2d) and nuts (3d).
• Attach the vertical standpipe (2) to the front base frame (11). To do so, use the bolts
(1k), washers (2d) and nuts (3d).
• Slide one of the support plates (53) together with the cylindrical rubber sleeves (38)
onto the weight guide tubes (7). Attach the tubes to the rear base frame (4)
according to the picture. Use the bolts (1d) and washers (2d) to do so. Slide all
weight plates (16) onto the tubes (7), and attach the weight stickers.
Please note: The holes in the weight plates intended for the locking pin (41) must
face down. Otherwise the locking pin cannot be inserted.
• Guide the select rod (15) through the holes in the center of the weight plates (16).
7
39
14
36
15
35
16
38
3d
2d
17
2d
4
1k
1k 2d 1d 2d
3d
21
10/6/2016 3:11 PM