Batteries; Setting The Remote Control Handset - WANDERS Solea Mode D'emploi

Batteries

Your Solea gas unit is delivered with batteries in the
receiver of the fireplace. If the electronic ignition system
of the unit does not work properly, it could be due to
empty batteries in the receiver. It is therefore advisable
to place new batteries in the receiver and the remote
control when installing your Solea. The receiver in the
unit works on 4 batteries of 1.5 V (type LR6 or AA) or
1 x 9 V alkaline. The remote handset is powered by a
9 V alkaline block battery. The batteries will last for about
one year.
When you ignite the fireplace and you hear a long
acoustic tone with short breaks it means that the batteries
in the receiver of the fireplace are due for replacement.
The same tone is also an indication for renewing the
batteries in the remote handset. Every time you use
the remote control for setting the unit you can see the
'transmit' signal in the top right corner of the display. If
you don't see this signal when pressing the buttons, the
batteries are due for replacement.
Replacing the batteries of the receiver.
Replacing the batteries in the remote control.
22

Setting the remote control handset

Setting your Solea remote is simple. Once you have
done it you can operate your fireplace in less than no
time. Your remote can even preset four time schedules
for the desired temperatures.
It is advisable to switch off your hearth when you
preset the remote to avoid accidentally changing the
temperature of your stove.
If your hearth has not received a signal from the remote
control for six hours, it switches automatically back
to the pilot flame setting. The pilot flame will burn
continuously.
If the pilot light has gone out you must wait at least five
minutes before lighting the hearth again.
Setting the time and date
When you put the batteries in the remote control handset
for the first time, the display will show 0:00 in short
flashes. Then the display will show the temperature, the
time (0:00) and in the low left corner it will show 'MAN'
.
Press the big buttons ▲ and ▼ simultaneously. The
display will flash the time. The ▲ button is for setting the
hour, and the ▼ button is for setting the minutes. Wait a
few seconds, or press 'OFF' to save the time.
You can switch from a setting in Celsius / 24
hours indication to the American Fahrenheit / 12
hours indication. Press both 'OFF' and
simultaneously for two seconds, and the indication will
automatically switch.
SET: changing the set user modus
The 'SET' button is used for setting how you want to use
your Solea.
There are four operational modes: MAN, ❂-temp,☽-
temp and TIMER. By briefly pressing the set-button you
can leaf through all four possibilities.
MAN
When the display shows 'MAN' you can manually turn
the fire higher ▲ and lower ▼. When you press and hold
the ▼ button the fire will burn at the lowest position,
which is the pilot flame position. Every time you press
▼ or ▲ when you are in another function (❂-temp, ☽-
temp or TIMER), the remote will switch to the 'MAN'
position.
❂
- temp
Briefly press the 'SET' button and the ❂-temp will appear
on the display. When you press and hold the 'SET' button,
the day-temperature indication will start flashing. You
▼ buttons