Dust Extraction; Mounting The Splinterguard - Festool TS 75 EQ Notice D'utilisation D'origine

English
Setting the riving knife:
8.1
► Move lever [8.3] as far as it will go,
► push switch lock [8.4] up and push sawing
unit down until it locks into place,
► loosen screw [8.1] with Allen key [8.2],
► set riving knife as shown in chapter
► tighten screw [8.1],
► put lever [8.3] back.
8.7

Dust extraction

WARNING
Health hazard posed by dust
► Always work with an extractor.
► Only use a dust extractor designed to col­
lect the specific type of dust and particles
from the material being cut.
► Follow OSHA and NFPA regulations to en­
sure a safe work environment.
Festool mobile dust extractor
A Festool mobile dust extractor with a suction
hose diameter of 1-1/16"/1-17/64" (27/32 mm)
or 1-7/16" (36 mm) (36 mm recommended due
to the reduced risk of clogging) can be connect­
ed to the extractor connector .
The adapter on a 1-1/16" (27 mm) diameter
suction hose is inserted into the angle adapter
[9.1]. The adapter on a 1-7/16" (36 mm) diame­
ter suction hose is inserted over the angle
adapter [9.1].
CAUTION! A static charge may build up if no
antistatic suction hose is used. The user may
receive an electric shock and the power tool's
electronics may be damaged.
12
9.1
8.4
8.3
8.2
8.8

Mounting the splinterguard

The splinterguard (accessories) significantly
improves the quality of the cutting edge of the
sawn workpiece on the upper side for 0° cuts.
► Attach splinterguard [10.1] onto the protec­
tive cover,
► Place machine onto the workpiece or the
guide rail,
8.6
► Press splinterguard down until it sits on the
workpiece and tighten it with the rotary
knob [10.2].
► Saw splinterguard in (machine to maximum
cutting depth and speed range 6).
10.1
10.2
Risc of injury
When making mitre cuts, the splinterguard
raises the portable circular saw from the
workpiece, which can lead to serious inju­
ries.
► Use the splinterguard only for 0° cuts. Al­
ways remove the splinterguard for mitre
cuts.
WARNING