Festool TS 75 EQ Notice D'utilisation D'origine page 16

English
The guide clearance of the saw table on the
guide rails can be set with the two setting
jaws [17.1].
The guide rails are equipped with a splinter­
guard ([17.3], [18.1]), which prevents splinter­
ing of the workpiece by holding the top edge of
the workpiece down as the teeth of the saw­
blade move upward against it. The spliterguard
has to be cut to size before the first use:
17.1
Position the guide rail for sawing the
splinter guard on a test piece of wood.
– Set the speed of the machine to level 6,
– Place the machine on the rear end of the
guide rail,
– Switch the machine on, press it down to the
set cutting depth and cut the splinterguard
along the full length without interruption.
The edge of the splinterguard now corre­
sponds exactly to the cutting edge.
18.1
The splinter guard needs to be replaced if it be­
comes damaged or worn:
Peel the original splinter guard [18.1] away
–
from the guide rail.
– As needed, clean residual adhesive and de­
bris from the guide rail.
16
17.3
17.2
17.4
18.2
– Peel off the plastic backing from the new
splinter guard to expose the adhesive.
– Without stretching the rubber, carefully
place the new splinter guard on the under­
side of the guide rail tight to the alignment
rib [18.2].
– Make sure the splinter guard is firmly
pressed down to the guide rail.
– Trim the splinter guard as described be­
fore.
Position the guide rail for sawing the
splinter guard on a test piece of wood.
11.3 Multifunction table
The mutifunction table MFT/3 makes clamping
the workpiece easy and allows you to saw large
and small workpieces safely and precisely us­
ing the guide system. Its many fields of applica­
tion make economical and ergonomically con­
venient work possible.
11.4 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool circular saw.
11.5 Side-mounted cover, false joints
The cover that can be mounted on the side of
the protective cover improves the effect of dust
extraction for 0° cuts.
Simultaneously, the cover can be used as a
false joint stop for false joint widths from 3/4"
(18 mm) onwards.
11.6 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.