Festo ELGA-TB-G Notice D'utilisation page 27

ELGA-TB-G/-RF(-F1)
• Attach the ELGA.
• Please select the corresponding accessories from our catalogue (è www.festo.com/catalogue).
1)
Foot mounting
HPE
Attach foot mounting to the
1 (è Fig. 2)
threads
bearing caps
1) See catalogue for additional accessories
Tab. 1
• Tighten the mounting screws uniformly with the following tightening torque.
Size
HPE Screw
Tightening torque
NST Screw
Tightening torque
Tab. 2
For installation in a vertical or inclined position:
Warning
Falling loads can cause personal injury and material
damage (crushing). If there is a power failure or the
toothed belt breaks, the work load will drop down.
• Make sure that you only use motors with an in­
tegrated spring-loaded holding brake.
• Check whether additional external safety meas­
ures against damage due to breaking of the
toothed belt are required (e.g. toothed latches,
moving bolts or emergency buffers).
Festo – ELGA-TB-G/-RF(-F1) – 1409b English
Slot nut mounting
NST
Slot nut mounting in the slot aJ
in the
70
M5
[Nm] 5.9
M5
[Nm] 5.9
1)
Profile mounting
MUE
Profile mounting in the slot of
the mounting surface 7
80
M5
5.9
M5
5.9
Fig. 6
1)
120
M8
24
M8
24
27