Cebora MIG Manuel D'instruction page 54

A
The screen displays the welding current in amps and the welding voltage in volts.
B
Hot Start.
This is the overvoltage supplied when the arc is ignited.
This is adjustable from 0 to 100% of the set welding current.
C
Arc Force�
This regulates the dynamic characteristics of the arc.
This is adjustable from 0 to 100% of the set welding current.
F
Menu�
MENU
Touch to select this function.
Select to enter the Main Menu.
SELECTING THE WELDING PROCESS, MIG, or MMA (see explanation in chapter on MIG Process).
Process
Parameters PROCESS PARAMETERS SELECTION
• Hot Start�
This is the overvoltage supplied when the arc is ignited.
This is adjustable from 0 to 100% of the set welding current.
Turn knob 2 to select the parameter and confirm the selection by pressing the knob.
Adjust this value by turning knob 2. To confirm the selection simply hold down knob 2 or key
Press the DEF key to restore factory settings.
• Hot Start Time�
This is the overvoltage time supplied when the arc is struck.
Adjustment ranges from 0 to 100 sec.
Turn knob 2 to select the parameter and confirm the selection by pressing the knob.
Adjust the value by turning same knob 2� To confirm the selection press knob 2 or key
Press the DEF key to restore factory settings.
54/58
.
.