Technical Specifications Table; Protections; Lock Protection; Thermal Protection - Cebora MIG Manuel D'instruction

page de 208

/ 208
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

Mains voltage U1

Tolerance U1

Mains frequency

Delayed fuse

Power consumed

Mains connection Zmax

Cos Φ

Welding current range

X Duty cycle according to standard IEC 60974-1

Open-circuit voltage U0

Maximum welding gas pressure

Maximum wire spool size

Usable electrodes

Performance ɳ

Consumption in stand-by

EMC emissions class

Overvoltage class

Degree of pollution according to IEC 60664

Certifications

Degree of protection

Weight

Dimensions (WxDxH)

2�2

Protections

2�2�1

Lock protection

If the welder malfunctions, a WARNING message may appear on display1. This identifies the type of defect. If the

message is still present after turning the machine off and on, contact the assistance service.

2�2�2

Thermal protection

This device is protected by a thermostat which prevents the machine from operating if the allowable temperatures are

exceeded. Under these conditions, the fan continues to operate and display 1 shows the flashing WARNING CODE tH.

INSTALLATION AND START UP

The system must be installed by qualified personnel. Carefully read the "Staff obligations and qualifications" section

in General Warnings code 3301151.

During transport of the device, ensure that applicable national and regional accident prevention guidelines and

regulations are observed. This applies in particular to guidelines concerning transport and shipping risks.

Carefully read the "Lifting and transporting" section in General Warnings code 3301151

Tipping a device over may endanger life! Position the device stably on a solid, flat base.

A maximum angle of inclination of 10° is allowed. Do not lift or transport live devices. The machine should not be

positioned on sloping planes, to prevent tilting or any uncontrolled movement.