Information/Settings Tab; Graphics Tab; Actionlog Tab - ITW Simco-Ion IQ Com Notice D'utilisation

Les langues disponibles

Figure 14, Graphics tab.

7.2.1. Information/settings tab

With the

buttons you can scroll through the various pages. The following data on the

operation can be found here:

Output voltage (kV): Indicates the current value of the high voltage on the HV output

Output current (mA): Indicates the current value of the current on the HV output

Output voltage peak (kV): Indicates the peak value of the high voltage on the HV output

Output current peak (mA): Indicates the peak value of the current on the HV output

Last warning: date and time of the last occurred Warning

Last alarm: date and time of the last occurred Alarm

Arcs per minute: displays the number of arcing per minute, see chapter 6.2.9

If a Sensor IQ Easy is connected to the IQ Com, the display will also show:

Web voltage (kV): the current average charge measured by the active segments of the

sensor bar, see chapter 6.2.7

Web voltage peak (kV): the maximum charge measured by the active segments of the

sensor bar, see chapter 6.2.7

The Graphics tab graphically shows the operation as function of the time.

Blue : the output voltage at the HV output (kV).

Yellow : the output current an the HV output (mA).

If the screen is clicked, the screen will "freeze", and "On hold" will show on the display. Clicking

the screen again will display the current value.

In the ActionLog tab, the changing status of the IQ Com is logged step-by-step. This is indicated

including the date and time the status change has occurred. The main messages are:

HV OK: the generator is turned on and is functioning properly

HV NOT OK: the generator is turned off or the high voltage doesn't function properly

REMOTE ON:

REMOTE OFF:

In the Maintenance tab (Figure 17) the ActionLog tab can be emptied.

IQComGeneratorConverter_UM_9752103110_NL_D_GB_F_V1_0

Figure 15, Action log tab.

Table des Matières

Simco-ion iq easy