Discs Playable On This Unit - Alpine IVA-W205 Mode D'emploi

page de 238

/ 238
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

Disc Accessories

There are various accessories available on the market for protecting

the disc surface and improving sound quality. However, most of

them will influence the thickness and/or diameter of the disc. Using

such accessories can cause operational problems. We recommend

not using these accessories on discs played in Alpine DVD players.

Transparent Sheet

• After turning the system off, a slight ghost of the image will

remain temporarily. This is an effect peculiar to LCD technology

and is normal.

• In cold temperature conditions, the screen may lose contrast

temporarily. After a short warm-up period, it will return to

normal.

Alpine products equipped with the Ai-NET bus, connected to the

IVA-W205, can be operated from the IVA-W205. Depending on the

products connected, the functions and displays will vary. For

details, consult your Alpine dealer.

Operation of some of the functions of this unit is very complex.

Because of this, it was deemed necessary to place these functions

into a special screen. This will restrict operation of these functions

to times when the vehicle is parked. This ensures the focus of the

driver's attention will be on the road and not on the IVA-W205.

This has been done for the safety of the driver and passengers.

Audio Processor Adjustments cannot be made if the car is moving.

The car must be parked and the parking brake must be engaged for

the procedure described in the Owner's Manual to be valid. The

warning "CAN'T OPERATE WHILE DRIVING" will be

displayed if any attempts are made to perform these operations

while driving.

• The IVA-W205 draws minimal current even when its power switch is

turned off. If the switched power (ignition) lead of the IVA-W205 is

connected directly to the positive (+) post of the vehicle's battery, the

battery may be discharged.

An SPST (Single-Pole, Single-Throw) switch (sold separately) can be

added to simplify this procedure. Then, you can simply place it in the

OFF position when you leave the vehicle. Turn the SPST switch back

ON before using the IVA-W205. For connecting the SPST switch,

refer to the "Connection Diagram of SPST Switch (Sold Separately)"

(page 73). If the power (ignition) lead is unswitched, it must be

disconnected from the battery post should the vehicle be left unused

for an extended period of time.

Disc Stabilizer