Setting The Visual Soft Button; Setting The Visual Button On The Unit; Setting The Digital Output; Subwoofer On And Off - Alpine IVA-W205 Mode D'emploi

Setting the VISUAL Soft Button

Setting item: VISUAL KEY
Setting contents: VISUAL / NAV.
VISUAL: Recalls the VISUAL selection screen by touching
[VISUAL].
NAV.: Switches directly to the navigation screen by touching
[VISUAL].

Setting the VISUAL Button on the Unit

The unit's VISUAL button function can be changed.
Setting item: CUSTOMISE KEY
Setting contents: AUDIO SETUP / SAT / TEL
AUDIO
SETUP: Pressing and holding VISUAL for at least 2 seconds
will recall the AUDIO SETUP screen.
SAT: If you press and hold VISUAL for at least 2 seconds
when either the XM or SIRIUS Receiver Box is
connected, the Weather or Traffic channels will be
recalled.
TEL: If you press and hold VISUAL for at least 2 seconds
when the Bluetooth Box is connected, the Bluetooth
TEL screen will be recalled.

Setting the Digital Output

To connect an audio processor using the optical digital output, set to
"ON" by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The setting
of Digital Output is decided.

Subwoofer On and Off

Setting item: SUBWOOFER
Setting contents: OFF / ON
OFF: Subwoofer output is off.
ON: Subwoofer output is on.

DISPLAY Setup

Display Setup Operation

To display the Display mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Display mode operation has been
released. Engaging the parking brake can reactivate the Display
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3) of "To
display the Display mode screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the Display mode screen."
The following steps 1 to 4 are common operations to each
"Setting item" of DISPLAY Setup. Refer to each section for
details.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [DISPLAY].
The DISPLAY SETUP screen appears.
3
Touch [ ], [ ] or [
change its setting.
Setting items:
VISUAL EQ / DIMMER / DIMMER LOW LEVEL / BACKGROUND
/ AUTO BACKGROUND / DATA DOWNLOAD / BASE COLOR /
PULSETOUCH / SCREEN ALIGNMENT
4
Touch [RETURN] to return to the previous screen.
Touch and hold [RETURN] for at least 2 seconds to return to
the main source screen that was displayed before the setup
operation was started.
• Immediately after changing the settings of Display Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
] etc., of the desired item to
37
-EN