Radio Setup; Digital Seek Setting (Hd Radio Mode Only); General Setup; General Setup Operation - Alpine IVA-W205 Mode D'emploi

RADIO Setup

Digital SEEK Setting (HD Radio mode
only)
After carrying out the steps 1 to 3 of "To display the General mode
screen" explained on page 33, perform the operation described below.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [SOURCE].
The SOURCE SETUP screen appears.
3
Touch [ ] of RADIO SETUP.
The RADIO SETUP screen appears.
4
Touch [ON] or [OFF] of DIGITAL SEEK.
ON: SEEK UP/DOWN is used only for the digital radio station.
OFF: SEEK UP/DOWN is used for DIGITAL and ANALOG radio
stations. However, the strong signals have priority during
SEEK.

GENERAL Setup

General Setup Operation

To display the General mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General mode, as long as the car's ignition has not been turned
off. It is not necessary to repeat the above procedure (1 through
3) of "To display the General mode screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the General mode screen."
The following steps 1 to 4 are common operations to each
"Setting item" of GENERAL Setup. Refer to each section for
details.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [GENERAL].
The GENERAL SETUP screen appears.
3
Touch [ ], [ ] or [ ], [ ], etc., of the desired
OFF ON
item to change its setting.
Setting items:
CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME /
DEMONSTRATION / BEEP / AUTO SCROLL /
LED DIMMER LEVEL
4
Touch [RETURN] to return to the previous screen.
Touch and hold [RETURN] for at least 2 seconds to return to
the main source screen that was displayed before the setup
operation was started.
• Immediately after changing the settings of General Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
33
-EN