Tyre Pressure; Instructions For Use; Starting The Engine; Starting The Machine - Grillo G131 Manuel D'utilisation

8) Check the tyre pressure following the table below:
5.00-12
6.5/80-12
9) Check the battery voltage. It must not be below 12,5 volt. If necessary recharge using a battey
recharger set at 12V on slow charge for two hours
IMPORTANT! During assembly take care not to get the polarity of the battery reversed.
10) Fill the tank with fuel using a funnel provided with a fine filter.
11) Check liquid levels with the machine set in horizontal position.

STARTING THE ENGINE

Before starting the engine:
- check the engine oil level (fig. 2, n. 20) and the gearbox oil level (fig. 4, n. 16); the oil level must
be between the two notches.
- check that all screws and nuts are well tightened, especially those fixing the blades and the
attachments to the walking tractor.
- check that all levers are in idle/neutral position.
- check that the air filter is clean and that the oil is at the right level (fig. 1, n. 10).
- check the oil in the rotary tiller gearbox (fig. 5).
Full the tank with fuel (fig. 2, n. 5) using a funnel with a very fine filter.
STARTING THE DIESEL ENGINE
To start the engine turn the starting key on the handlebar clockwise (fig. 1, n. 9).

STARTING THE MACHINE

Below the decals positioned on the gearbox housing where the levers are mounted. These decals
show how to engage the speeds in both the walking tractor and sickle-bar version.
Translation of the original instructions

TYRE PRESSURE

2 PLY RATING
2 " "

INSTRUCTIONS FOR USE

9
1,5 BAR
1,5 BAR "