Maintenance - Imetec P8403 Instructions D'utilisation

REPLACING THE OLD ANTI-SCALE FILTER
NOTE: The anti-scale filter (14) used may contain drops of water.
Place a cloth under the anti-scale filter to prevent these drops falling on to the floor.
ZEROCALC ANTI-LIMESCALE SYSTEM
Replace the anti-scale filter (14) when the red filter change indicator light (8A) begins flashing and the
iron emits a warning buzz.
To replace the old anti-scale filter, proceed as follows:
Open the filter flap (2).
Remove the anti-scale filter (14) from its casing.
Remove the protective red rubber pads from the anti-scale filter (14).
Insert the anti-scale filter (14) in the housing and pressing firmly into position [Fig. B].
Closes the filter flap (2).
Keep button 8B pressed for at least 1 second.
The iron will make a sound, and the indicator light (8A) will switch off.
The iron is now ready to be used.
NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
This is absolutely normal and is caused by the anti-scale filter filling up. Keep the steam
request button (13) pressed for at least 1 minute, until the buzzing stops and the iron begins
to deliver steam.
NOTE: the electronic system modifies steam emission to safeguard the lifespan of the
product. The anti-scale filter (14) must be replaced as soon as possible.
Failure to replace the anti-scale filter (14) will invalidate the warranty.
CLEANING
WARNING! Make sure the plug is disconnected from the
socket and the plate has cooled down completely before
cleaning the iron.

MAINTENANCE

EN
19