Use; Filling The Tank - Imetec P8403 Instructions D'utilisation

Sort the laundry according to the international symbols shown on the label; if this is missing, sort
according to the type of material.
Start by ironing the garments that require the lowest temperature.
SETTING THE ANTI-SCALE FILTER DURATION
After inserting the anti-scale filter, you can set its duration on the basis of the hardness of the water used
for ironing.
Turn the ON/OFF switch (5) to ON. The 8D indicator turns on, in correspondence of the INTELLI position,
and the iron starts to heat up. In this phase, you can set the duration of the anti-scale filters.
If the water used is fairly hard (i.e. from 9°f to 18°f), no modification is needed as the filter duration is
already set automatically.
If the water is soft (i.e. up to 8°f), the duration can be increased as follows:
1. Press button 8B for at least 2 seconds.
2. The product will beep and the yellow Filter indicator light will turn on (hard water setting between 9° f
and 18°) (8A) and at the same time, the INTELLI program turns off (8D).
3. To alter the setting of the filters, briefly press button 8B. At this point, the indicator light turns green.
To confirm, keep button 8B pressed for at least 1 second. The iron will emit a sound and the «Filter »
indicator light (8A) will switch off. This means the duration setting has been correctly selected.
The previously selected temperature indicator light will now automatically come back on again, flashing.
Wait for the light to stop flashing before using the iron.
WARNING! This appliance is not to be used if it has been
dropped, if there are visible signs of damage or if it is leaking
water.
WARNING! DO NOT pour diluting agents, scented liquids or
descaling agents into the reservoir as the use of these
substances can damage the product.
WARNING! Do not use water from dryers, air-conditioners or
tumble dryers, filtered water with water softeners, or
rainwater.
The reservoir may contain some water as each product is tested before being put on the market.

FILLING THE TANK

Check that the power supply cable with plug (7) is plugged into the socket.
Open the water fill cover (1).
Pour water into the tank (3) very slowly to avoid overflowing.
Do not exceed the maximum filling level indicated.
Close the water fill cover (1).
SELECTING THE IRONING PROGRAM
Plug the power supply cable with plug (7) into the socket.
Turn the ON/OFF switch (5) to ON.

USE

EN
17