Troubleshooting - Imetec P8403 Instructions D'utilisation

Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait until the iron cools down completely.
Remove any starch deposits or residue on the surface of the base of the iron (12) with a damp cloth and
EN
non-abrasive liquid detergent.
Clean plastic parts with a damp cloth.
Then wipe with a dry cloth.
STORAGE
Fold the mono-tube (10) in half, with the iron resting on its stand (9) [Fig. C].
Insert the folded mono-tube into the recess (4), sliding it inside the special clamp.
Slide the mono-tube (10) along the entire cable recess (4).
Insert the mono-tube (10) behind the second clamp [Fig. D].
WARNING! Risk of fire. Wait for the appliance to cool
completely before storing it.
This chapter describes the most common problems that can arise using the appliance. If the problems
cannot be solved with the information below, please contact the Authorised Assistance Centre.
Problem
The plate (12) remains
cold or does not heat
up.
The plate temperature
LED (11) goes on and
off.
Only a little steam
or none at all is
dispensed.
The impurities that
come out
from the steam holes
stain the garments.
20

TROUBLESHOOTING

Possible cause
There is no power
supply.
Normal procedure.
There is not enough water in
the reservoir (3).
The anti-scale filter (14) is no
longer effective.
The anti-scale filter (14) is not
inserted correctly.
Chemical additives, scented
liquids or descaling agents are
being used.
Starch is being used.
Solution
Check if the power supply cable plug (7)
is inserted correctly or try inserting it in
another socket.
The plate temperature control LED (11)
switching ON and OFF indicates the
heating phase of the iron. The LED goes off
once the set temperature is reached.
Fill the reservoir (3).
When the anti-scale filter (14) is no longer
effective, the electronic system modifies
steam emission to safeguard the lifespan
of the product.
Check the filter change indicator light
(8) and the acoustic signal are ON, then
replace the filter as explained in the
specific paragraph.
Cross-check the anti-scale filter insertion
process as indicated in the specific
paragraph.
These substances damage the product:
do not add additives to the water in the
reservoir.
Always spray the starch on the reverse
side of the fabric.