Maintenance - Imetec F4101 Mode D'emploi

EN
Filling the reservoir while ironing
• When the water in the reservoir is below the minimum level, the no water LED (7) lights
up and the iron stops producing steam.
• Lift the reservoir water fill cover (1) and fill the water reservoir (2) without overflowing.
Once finished, lower the water fill cover (1) completely.
• The appliance is ready to continue ironing.
Cleaning the boiler
The boiler must be cleaned after 20 hours of operation, in order to prevent limescale from
forming.
The boiler cleaning LED (6) starts blinking when the boiler must be cleaned.
However, you can start ironing. Follow the "Sequence of operations" below to clean the
boiler.
ATTENTION!
The boiler must only be cleaned when cold.
NOTE:
Failure to carry out this operation will make the warranty null and void.
Sequence of operations:
• Press the ON/OFF button (12).
• Disconnect the plug (13) from the socket.
• Let the boiler cool down for at least 4 hours.
• Place the boiler on a wash basin.
• Shake the base to help the limescale chips detach (Fig. B).
• Loosen the cleaning cap (11) by turning it anti-clockwise (Fig. C).
• Let the water and limescale drain from the hole.
• Shake the boiler once again for the remaining water and limescale chips to come out.
• Tighten the cleaning cap (11) by turning it clockwise.
• Refill the water reservoir (2) before using the boiler again.
• Insert the plug (13) in the socket.
• The boiler cleaning LED (6) continues blinking: press the ECO button (3) until the LED
goes off.
Make sure the cleaning cap (11) is tightened well.
Do not clean the boiler with detergents, anti limescale products, vinegar
or any other substance.
14

MAINTENANCE