Tunturi E60R Mode D'emploi page 4

L OW ER F R A M E
Slide the retaining plate located underneath the
seat frame to the front of the bar. Fasten the lower
frame to the seat frame using the shorter M8 screw
(A) in the front and longer M8 screw (B) in the
back. Place the shorter screw (A) into the frame
hole from the end of the lower frame and the
longer screw (B) through the frame. Pass the screws
through the holes in the lower frame so that they
match the threads in the retaining plate. Make sure
the screws are tightly fastened.
F EE T
Secure the rear foot with two M10 bolts (C) and
washers (D). At this point tighten the bolts only
with your fingers. Lift the cycle on the floor and
turn it right side up. Fasten the front foot with the
transportation wheels to the front frame the same
way.
J OIN IN G T H E FR AM ES
Join the front frame and seat frame by pushing one
tube inside the other so that the screw holes in the
tubes match together. Fasten the frames with two
M8 screws (E) and washers (F). Tighten the rear
and front foot screws and push the plastic caps over
the screw heads.
4
S EAT BACK
Push the fastening screw (G) through the hole in
the seat frame tube and the assembly plate. Place
the bushing (H) on the fastening screw and secure
the plate by tightening the nut (I) on the fastening
screw. Remove the fastening nuts and washers
of the seat back and attach the seat back to the
assembly plate with them. Finally, push the plastic
caps over the nuts.
METER
Remove the tape covering the wire coming out
of the frame tube, and connect the wire with
the connector inside the meter tube. Thread the
connected wire carefully into the frame tube, and
push the meter's connecting tube into place within
the frame tube so that the heads of the screws point
to the seat.
Do not remove the fastening screws, but
N O T E !
tighten the two fastening screws of the connecting
tube by pushing the Allen key through the hole
in the frame tube to the screw head and turning
counter-clockwise. Loosen the two screws for the