Lenze starttec Instructions De Montage page 85

Show/Hide Bookmarks
Switch-on sequence
1.
Set the rated current according to
the connected motor using the step
switch [S]
2. Set the acceleration time t
potentiometer [P2] potentiometer [P2]
Lenze setting: 0 s
0 0 0 0 0
3.
Set the start voltage (V
[P1]
Lenze setting: 0 %
0
When you are ready with parameter setting:
4. Close the starttec housing
5. Ensure that the starttec is inhibited
after mains switch on.
6. Switch on the mains
7. Switch on the 24 VDC supply for the
starttec control
8. starttec enable
9. If necessary, release the brake
10. Motor start 0
11. The drive should be running now
L
Multi-motor operation - without keypad
0
start011
with the
ir
CINH CINH CINH CINH CINH CINH CINH
E1 E1 E1 E1 E1 E1 E1
M M M M M M M
3.00 s 3.00 s 3.00 s 3.00 s 3.00 s
E3 E3 E3 E3 E3 E3 E3
start012 start012
) with
start
100% 100%
U U
100.0 %
start008
Terminal X3/28 = LOW
Terminal X3/28 = HIGH
Terminal X3/E3 = HIGH
Motor 1 Terminal X3/E1 = HIGH
Motor 2 Terminal X3/E2 = HIGH
EDK71MMXXX-020 DE/EN/FR 1.0
Commissioniong
t ir t ir t ir t ir t ir t ir t ir t if t if t if t if t if t if t if
U U
out out
start start
0 0
0 0
Note
Setting values are listed
l
in the table above
See also ¶ 13 See also ¶ 13
l l
Use the keypad and code
l
C0120 for fine
adjustment
CINH Enable starttec via X3/28
E1 Motor 1 start
M Motor 1 voltage flow
E3 Brake control
t
Acceleration time
ir
t
Deceleration time: 0.50 s
if
t t t t t t t
(C0013)
start013 t t013
Check the settings under
C0012 with the keypad
With V = 100 %, the
l
start
acceleration time t
active
Check the settings under Check the settings under
l l
C0016 with the keypad
t t
start028
7
is not
ir
31