Step 2: After the transmitter and the receiver are connected, both switch to
normal operation and the LED on the receiver flashes slowly.
!
The Binding procedure usually only takes a few seconds.
Troubleshooting: Binding
Error:
The LED on the receiver flashes rapidly during the binding procedure and for
several seconds after.
Reason:
Unable to find an M-LINK signal of sufficient strength.
Solution:
· Reduce the distance between your transmitter and the receiver aerials.
· Ensure that your transmitter is connected in binding mode.
· Repeat the binding procedure.
LED codes
LED code 1
LED code 2
LED code 3
LED code 5
LED code 6
LED code 7
LED code 8
LED ON -> no reception
1.6 sec. -> binding process running
1.6 sec. -> normal receiving mode, no errors
acknowledgment signal
1.6 sec. -> between 1 and 19 errors
1.6 sec. -> between 20 and 49 errors
1.6 sec. -> 50 or more errors
Functions of the SET button
If the SET button on top of the receiver is pressed when being turned on, the
binding procedure begins. In receiving mode, two additional functions can be
triggered using the SET button. Which function is selected depends on how long
the button is pressed:
1. Save error counter or FAIL-SAFE position:
Press the SET button for between 0.5 and 1 second.
2. RESET the receiver to default settings:
Press the SET button for longer than 10 seconds.
While the SET button is being pressed, the LED emits timestamps indicating the
length of time the button has been pressed.
Press and
hold the SET
< 2 seconds
button for
LED:
OFF
Save error
Task:
counter/FAIL-
SAFE
Please note: After saving, the LED emits the acknowledgment signal.
Between 2 and 10
> 10 seconds
seconds
ON
OFF
RESET to
default settings
23