List Of Parts - Bresser NATIONAL GEOGRAPHIC 8-24x50 Mode D'emploi

List of Parts

Centre axle
B
Ca Twist-up eyecups
or
Cb Rubber eyecups
Dioptre adjustment
D
Body of the binoculars
E
Lens tube
F
Central focussing wheel
G
Eyepiece
H
Objective lens
I
Threaded tripod connection
J
Image circle with correctly set eye distance
1)
Zoom lever
1!
Eyepieces for spectacle wearers
Depending on the model, your binoculars are equipped with either twist-up eyecups (2a) or rubber eyecups
(2b). Since there is a larger distance between the binocular eyepiece and the pupil for those wearing glasses,
both eyecup varieties can be adjusted individually.
Twist-up Eyecups (2a)
Screw in the twist-up eyecups (2a) to use the binoculars while wearing glasses. If you are not wearing glasses,
unscrew the eyecups to achieve the required distance from your pupils.
OR
Rubber Eyecups (2b)
To use the binoculars while wearing glasses, turn the rubber eyecups (2b) toward the sides and down. If you
are not wearing glasses, leave the eyecups in the upright position to achieve the required distance from your
pupils.
Adjusting the eyepiece distance
The distance between your eyes differs between individuals. To achieve perfect interaction between your eyes
and the eyepieces of your binoculars, set the angle at the centre of the binoculars (1) so that you see a circular
image (10). Note this setting for later use.
Adjusting the focus
Look through your binoculars with your right eye closed. Now adjust the image for your left eye using the centre
wheel (6) until it is sharp and clear. Close your left eye and adjust the image for your right eye using the dioptre
ring (3) until it is also sharp and clear.
Mounting the binoculars on a tripod
Your binoculars have a threaded tripod connection (9) built in. The required tripod adapter is available as an op-
tional accessory (Art. No. 19-16000 or 19-16500). With this accessory, you are able to mount your binoculars
on a tripod with a DIN mounting thread (e.g. Art. No. 49-22100).
DE EN FR NL ES IT PL PT RU
9 9