Bury technologies CC 9050 Mode D'emploi page 18

Operating guidelines
32
You have two possibilities to access the alphabet:
The characters at the beginning can be accessed via the left scroll key
starting from character „H". With the right scroll key you start sear-
ching at character „P". Select a character (left/right) and confirm this
with the selection key. Entries are then displayed starting from this
character.
Info
In the menu Info you receive information on the installed software and
hardware of your hands-free car kit. You should write down these data
if you have problems in using the HFCK with your mobile telephone and
contact the Bury hotline or if you e.g. wish to update the firmware (the
Display with English menu navigation
operating system of the HFCK).
It can be useful to update the firmware (information at www.bury.com)
in case of a mobile phone change or when new functions have been
implemented. You can find the version number of the firmware after
the name of the HFCK, e.g. „CC 9050 V3.0a". In the sub-menu <DSP
Info> you can see whether the ‚digital signal processor' (DSP) in the
HFCK and in the mobile telephone (if available) is activated. This enab-
les an improvement of the reproduction of the spoken language and
supports the noise suppression.
Service
In the menu Service you can set the colours for the background and
the text. Furthermore, the next sub-item enables you to switch on and
off the DSP-function in the mobile telephone as well as in the HFCK.
You can update the firmware of the HFCK via the sub-item update. A
detailed description and the corresponding firmware can be had on the
Internet at www.bury.com. The next sub-item enables you to again
synchronise the phone book with your mobile phone.
Bluetooth
Under the menu item Bluetooth you will find a list of the mobile tele-
phones which have already been successfully paired with the HFCK.
After switching on the HFCK, the entries saved here are scanned for
establishing a Bluetooth connection. You can delete mobile telephones
from the list if they are definitively no longer used. Select the respecti-
ve entry with the scroll keys and then press key 5. Please select the
function ‚delete'.
This menu enables you to connect the hands-free car kit to your mobi-
le telephone. Please select the function ‚connect'. A small icon indicates
the profile the mobile telephone was connected to the HFCK last. A car
signalises the profile „hands-free" and a grading key the profile „A2DP".
If both symbols are displayed, you will be subsequently asked to select
the profile you want to connect the mobile telephone again.
Language
In the menu item Language you can change the menu language.
Therefore scroll to the required language and then press the selection
key. After a few seconds the new menu language is loaded.
Day/Night
As the lighting conditions vary according to the time of the day, you
have the possibility to reduce or increase the brightness under the
menu item Day / Night. This enables a better legibility of data on the
display.
Sleep Mode
In the menu item Sleep Mode you can activate a screen saver. It ap-
pears if you have not made any entry or pressed any key at the monitor
for 15 seconds. The display thereby darkens slowly until no contents
are visible, regardless if a mobile telephone is connected to the HFCK
or not. During an active phone call, the screen saver is deactivated.
Music
In case of an incoming call many mobile telephones transmit the proper
ring tone to the HFCK, but there are also exceptions. In this case, you
can configure a signal tone to be reproduced under the menu item
Music.
33
Display with English menu navigation
Display with English menu navigation