Bury technologies CC 9050 Mode D'emploi page 15

Installation of the hands-free car kit
26
ATTENTION:
If you also connect the blue cable to clamp 30, the hands-

free car kit will be permanently supplied with power. If the
vehicle is not running for a longer period, this could lead to
a discharge of the car battery.
Now connect the microphone (connection 4) and the monitor plug (con-
nection 5) to the electronics box.
The hands-free car kit reproduces the interlocutor's voice output during
a phone conversation via connection 3. You can connect a separate
loudspeaker (Bury accessories) or the phone-in input of your radio (if
available) to this connection via a phone-in adapter. The connection of
a loudspeaker switch box (Bury accessories integrated in CC 9051) is
also possible. The last two models use the vehicle's sound system for
voice output.
Stereo music is output at connection 2. Here you can connect the aux-
in input of your radio (if existent) via adapters available at local retai-
lers. For the connection to the hands-free car kit, the adapter must
have a 3.5 mm stereo jack. Depending on the car radio, the other end
must be selected otherwise. If your radio does not have an aux-in, you
can use the car CD/MP3 adapter from the Bury accessories programme
to enable the reproduction of music via your radio.
1
2
3 4
5
6. Installation instructions for the fuses
Please cut through the red, the black and the blue cable by means of a wire cutter or scissors. Now
insert the two endings of the red cable resulting from the cut into one of the binders, then close it. If
you hear two clicking noises, the clamp snapped in properly. Now insert one of the fuses and then
repeat the procedure with the other cables.
27